Showing posts with label loads. Show all posts
Showing posts with label loads. Show all posts

Jan 9, 2012

Corry, Pa

I have been offered several loads in the past few months that would test my merit and challenge me. I was nervous, of course, but still eager to try to get them loaded. One load involved a F350 dually. I cannot remember what the other one involved. But with enough units and a quick loader trailer, the challenge can get pretty intense. For those of you unfamiliar with car-haulers, independent decks, drops pockets and sliding decks offer a tremendous advantage over my trailer. My top deck of the trailer is one piece, so if the vehicles are too long to fit, they are just too long. Split decking can also help with height and angles, but once again... no decks to split load on.

Last week, I was told to head to Corry, Pa, located just southeast of Erie. My load was 5 Chevy 1500s. I was told that if I could fit a 6th unit on the load to go for it. I immediately replied that if it could be done, I would do it! I was ecstatic!

After trudging through the back roads in the remnants of an earlier lake affect snowstorm, I found my dealer and set about my task. I was attempting to load 3 Extended Cabs and 3 Crew Cabs. I had hope in my eye, when I got the trucks placed, but I ran into a little problem. 14'2" !!! There were 2 things holding me back from successfully stacking the tractor. 1) the lower truck was too long to fit in the drop pockets over my drive tires, and 2) my #3 cylinder is fully extended. Had I been able to raise it higher, I could have dropped the bed of the truck and placed the crown of the windshield at a better angle for the height. As is, I couldn't drop the the second truck any lower because the windshield of the lower truck was in the way. With only 2 on the tractor, I would now have to try and squeeze 4 of them on the trailer. I called the previous driver of this truck and asked if it could be done. He said yes, and told me the positioning. I replicated his instructions, but decided that his configuration was all wrong.

Now with a little more experience, I would have known better to begin with. But, I have been so busy shoving cars on and delivering, that I have not paid a lot of attention to the actual potential of my trailer. Shame on me!! It is definitely time to get familiar with my truck. I am sure several of you can tell me what is wrong with this picture....

Wait for it

Yup, you guessed it. The top units should have been turned so that the beds were bumper to bumper, therefore creating the angles I needed with the windshields. It may not have worked anyways, but that is one of the few tricks I did not employ. And believe me, I tried everything I could think of at the time. Including chaining to the frame to suck down the suspension of the rear of the top. Just could not quit get it down. After 7 hours of playing with this load, I decided to throw in the white flag. My original load was 5 units, so I knew I was still good to go. But, damn it, I wanted that 6th unit. Just to get a little ego boost, I suppose. After speaking with my mentor and one of the higher ups, it was told that the odds of me getting that load to fit were slim to none with the quick loader. Not because of my lack of skill, but simply because of the lack on independent decks and appropriately placed drop pockets. Now, I am really eager to get a huge load..... But first, this one had to be delivered to Burgaw, NC.

Getting there was no problem, but getting back to South Carolina was a different story....